Days Until Halloween!!
*This product is custom made.
The PicoBoo 104 is our “go to” controller that we use on all 2 or less movement animations WITHOUT AUDIO.
This controller is very simple to use, does not need a PC to program and includes the following:
– Two 10 amp relay outputs
– 30 watt Class D amplifier
– 12V 1Amp Power Supply
2 in stock
Passive Infrared Sensor (+$38.00)
Beam Break Sensor (+$62.00)
Step-Mat (pressure Pad) (+$65.00)
Hand Held Trigger (+$38.00)
Add economy outdoor speaker (+$45.00)
Add outdoor speaker (+$65.00)
Add indoor amplified speaker (+$105.00)
All programming of outputs and sounds are done in real-time using the programming buttons on the PicoBoo. Tap record, animate the outputs, then tap record again to save. It’s so easy!
The PicoBoo JR has two 10 amp relay outputs brought out to a pluggable terminal block. Two relays give the flexibility to control different voltages, maybe one for a light, and one for a 12 volt solenoid. Each relay also has both a normally-open and normally-closed contact.
Up to 2 minutes of animation at 30 frames per second can be recorded.
The PicoBoo JR has a trigger input that can be used to trigger the scare automatically. This is most commonly used with PIR motion sensors, beam sensors, hand triggers, or pressure mats. If you want the PicoBoo to loop your scare indefinitely, connect the – and IN trigger pins with a small wire jumper.
Our selection of triggers can be seen here.
Just like its PicoBoo brothers, the PicoBoo JR has a write protection mechanism that helps prevent accidental or unwanted program changes.
Quick Start Guide Download
Operating Manual Download
There are no reviews yet.
Only logged in customers who have purchased this product may leave a review.